[Syrupmakers] Miracle 1

[BOBBY and JOYCE MCDANIEL]

Richard Have you are anyone heard of Government Green # 16 I'm want info. on this variety.  Thanks Bobby  Sugarcane.
  ----- Original Message ----- 
  From: reit8472 
  To: syrupmakers at syrupmakers.net 
  Sent: Saturday, December 09, 2006 8:54 PM
  Subject: Re: [Syrupmakers] Miracle 1


  Hi Richard, I for one would like it if you could email the photos to me. We have two varieties we use and not real sure what they are.

  Ken Reitsma

  reit8472 at sw.rr.com
    ----- Original Message ----- 
    From: Richard Harrison 
    To: syrupmakers at syrupmakers.net ; christison at coastalnet.com 
    Sent: Saturday, December 09, 2006 7:59 PM
    Subject: RE: [Syrupmakers] Miracle 1


    Ken,
       I have recent photos of several sugarcane varieties....would be interested in posting some for the Forum. Please let me know how this would be possible.
                                  Richard Harrison

    Ken Christison <christison at coastalnet.com> wrote:
      Sam,

      Is your pole plate, or more properly, the lever cap, slanted
      or is it parallel to the ground? If it is parallel it would be easy
      to fasten a piece of pipe to it with U bolts and suspend it above 
      the ground a few inches. A lead hammer or a sturdy block of 
      oak or hickory can come in handy for striking blows to the shaft
      from the sides. You won't need to strike it real hard, but give it
      a few forceful whacks every time you go by. Does the shaft
      stick up through the lever cap? If so, that makes it a little harder
      to keep penetrating oil applied. If there is a recess, you can fill it 
      with P-B Blaster or even brake fluid in a pinch. It doesn't pay to 
      hurry. I have heard of folks lighting up brake fluid in a vertical
      cylinder which supposedly helps the fluid to penetrate. Can't hurt
      to try this if you don't have a acetylene torch.

      By the way, the lever cap and shaft are a snug taper fit, so no need
      for set screws or pins.

      The bearings are simply half shells that fit between the shaft and the 
      cast iron bearing holder. They are usually about a quarter inch thick
      and in this case probably about 3 inches long. They can be either 
      brass, or one of the nylon derivatives used for bearing material.


      We don't allow attachments on the list, so your best bet for sharing
      pictures is to post them to one of the free photo hosting services, or
      you can contact me and I will be glad to post them temporarily for
      the list.

      Take care.

      Ken Christison
      christison at coastalnet.com






----------------------------------------------------------------------------
    Need a quick answer? Get one in minutes from people who know. Ask your question on Yahoo! Answers. 


----------------------------------------------------------------------------


    ____________________________________________________
    If you grow sorghum and are not a member of the NSSPPA 
    please check us out at: http://www.ca.uky.edu/nssppa/
    Syrupmakers archives are located at:
    http://lists.syrupmakers.net/pipermail/syrupmakers/
    ____________________________________________________


------------------------------------------------------------------------------


  ____________________________________________________
  If you grow sorghum and are not a member of the NSSPPA 
  please check us out at: http://www.ca.uky.edu/nssppa/
  Syrupmakers archives are located at:
  http://lists.syrupmakers.net/pipermail/syrupmakers/
  ____________________________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.syrupmakers.net/pipermail/syrupmakers/attachments/20061209/90cab526/attachment.htm